Black Widow Security BW X-Z Series Informations techniques télécharger pdf (Page 13)

Mounting the Wall Bracket

(Refer to figure 2.3)

WARNING: The wall bracket is used to support the entire weight of the

machine. The lag screws are intended for use in wood-framed walls

only. Both screws must be engaged for their entire length into the

wood of the wall studs (upright framing members.) If for any reason

these conditions cannot be met, STOP the mounting process and con-

tact Arachnid. DO NOT PROCEED.

With the proper tools at hand, mount the wall bracket as follows:

1. Remove and discard the two screws holding the Z-bracket to the back of

the cabinet.

2. Push down on the bracket to release it from the cabinet.

3. Locate the two adjacent wall studs where the game will be mounted and

mark them for reference.

4. Measure up from the floor 78-1/4 inches and mark a short horizontal line

across one of the studs.

Installation and Assembly

2.3

Figure 2.3

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 154 155

Pas de commentaire

Black Widow Security BW X-Z Series Informations techniques Page 13