Black Widow Security BW X-Z Series Informations techniques télécharger pdf (Page 121)

Expansion Cards

To install an Expansion Card:

1. Disconnect all relevant cables and power cords to the CPU.

2. Loosen the holding latch located at the top, front, center of the CPU and

slide the latch up and out of the way.

3. Slide the CPU out of the cabinet.

4. Locate an empty card slot for the expansion card to be installed.

5. Remove the corresponding slot cover from the chassis by removing the

retaining screw and pulling the slot cover up and out of the chassis.

Keep the retaining screw nearby.

6. Perform any configuration, as needed, for the card you are installing.

(See the individual card information, later in this section, for configura-

tion instructions.)

7. Holding the top corners of the card, carefully align the edge connector

with the card slot (see illustration).

8. Push the card into the slot using a slight rocking motion until the card is

firmly seated in the slot.

9. Secure the card’s slot bracket to the chassis with the screw removed in

step 5.

10. Make sure the card had been placed evenly and completely into the

card slot.

11. Slide the CPU back into the cabinet and secure the holding latch.

12. Connect all relevant cables and power cords.

IOB Card

Technical Description

T2.3

Edge

Connector

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 154 155

Pas de commentaire

Black Widow Security BW X-Z Series Informations techniques Page 121