Black Widow Security BW X-Z Series Manuel d'installation télécharger pdf

INSTALLATION MANUAL

BW-1060

SELF-CONTAINED

SECURITY SYSTEM

Channel

Before Installing:

1. Read the INSTRUCTIONS!

2. USE A DIGITAL OR ANALOG

VOLT/OHM METER

3. BEFORE MOUNTING THE PRODUCT

CHECK THE POSSIBLE LOCATIONS

FOR THE SIREN AND LED BEFORE

YOU PERMANENTLY INSTALL THEM.

4. PROTECT THE VEHICLE BY USING

FENDER COVERS.

5. ROLL DOWN THE DRIVER’S WIN-

DOW BEFORE STARTING THE INSTAL-

LATION.

6.ALWAYS LOOK BEFORE DRILLING.

MAKE SURE YOU WILL NOT CAUSE

DAMAGE TO VEHICLE HOSES, ELECTRI-

CAL LOOMS OR PHYSICAL DAMAGE

TO VEHICLE.

Timing Information:

Automatic reset time: 45 seconds,

Panic output reset time: 45 seconds,

Arming time: (when all inputs are mon-

itored): 3 seconds-active arm.

Armed output: The Gray wire will pro-

duce a grounded output when system is

armed.

Flashing Parking Light Output:

Armed: 1 second pulsed, Disarmed: 2-one

second pulses.

System triggered: 1 second

pulse on, 1 second off, repeated for 45

seconds.

Input Zone Out Feature:

If a door input remains on for 4 consecu-

tive cycles (45 seconds) that input will be

ignored. If the input returns to a non-trig-

gered state for 30 seconds it will be mon-

itored by the system again.

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - INSTALLATION MANUAL

1INSTALLATION MANUALBW-1060SELF-CONTAINEDSECURITY SYSTEM 1ChannelBefore Installing:1. Read the INSTRUCTIONS!2. USE A DIGITAL OR ANALOGVOLT/OHM METER 3

Page 2

PROGRAMMABLE FEATURESTo program these specific featuresfollow the procedure:1. Anti Car Jacking: Turn the ignitionkey to the ON position.Within 5 seco

Page 3 - INSTRUCTIONS:

INSTALLATIONINSTRUCTIONS:1. Mount the Siren:Locate a suitable place under the hood,away from hot and moving engine partssuch as manifolds, turbo charg

Page 4

shows 12V+ when only the parking lightsare switched on. European vehicles mayrequire an additional relay if they haveseparate wires that switch on the

Page 5 - SIREN CHIRP STATUS

5STATUS INDICATOR (LED) FUNCTIONSOff= System off in Active ModeSlow Flash= System ArmedRapid Flash= System was triggeredOn Solid= 3 second final prear

Page 6 - IGNITION

6CHIRP STATUS LED STATUSA) 1 Chirp = System Armed A) Fast Flashing = System has been triggeredB) 2 Chirps = System Disarmed B) Steady Flashing = Syste

Page 7 - FUNCTION

#1)2)3)4)5)6)7)8)COLORRedBlackBlueGrayYellowRed/BlackGreenBlackFUNCTION+12V InGround(-) TriggerStarterInterruptFlashingLights(+)LED(+)IgnitionInput (+

Page 8 - TROUBLESHOOTING