Black Widow Security BW FM 6150 Manuel d'utilisateur télécharger pdf (Page 3)

CHIRP DELETE

For full time silent operation, the ARM/ DISARM

chirps can be permanently disabled. This feature

must be programmed during installation.

IGNITION LOCK*

The ignition locking feature allows the doors to

automatically lock when the ignition key is

turned on, and automatically unlock when the

ignition key is turned off. This feature may be

disabled during installation.

REMOTE PANIC

In the event of an emergency (PANIC) situation,

the system’s siren can be triggered for 45

seconds to attract attention.To activate the Panic

Feature, press transmitter button 1 for 3

seconds:

• The siren will sound.

• The parking lights will flash.

Press button 1 to exit panic mode and rearm

the system. Press button 2 to exit panic mode

and disarm the system. The Panic Feature will

operate when the ignition is on.

EMERGENCY OVERRIDE

If the transmitter becomes lost or fails to

operate, the system can be disarmed by using

the emergency override feature.

To override the system:

1. Enter the vehicle.

• Because the system is armed, the siren

will sound.

2. Turn on the ignition key.

3. Press the Valet switch for 5 seconds.

• The siren will stop sounding.

• Starter defeat bypassed.

VALET MODE

When the system is placed into the Valet Mode

the security system will be disabled.

However, the optional keyless entry and trunk

release and remote start features will still

function if installed.

NOTE: Remote Start feature maybe disabled

during valet mode if programmed during

installation.

To enter the Valet Mode:

1. Be sure the system is disarmed.

2. Turn the ignition key on.

3. Press and hold the valet/service mode

switch for 3 seconds.

• The siren will chirp once.

• The LED will turn on solid indicating

the system is in Valet Mode.

To exit Valet Mode:

1. Turn the ignition key on.

2. Press and hold the valet/service mode

switch for 3 seconds.

• The LED will turn off.

• The Siren will chirp 2 times.

OPTIONAL TRUNK RELEASE

Press button 3 for approximately 2 seconds to

open the trunk.

OPTIONAL TRUNK DISARM

The trunk disarm feature allows the alarm to

disarm automatically whenever transmitter

button 3 is used to activate the optional trunk

release. This eliminates having to first disarm

the alarm before activating the trunk release.

NOTE: This feature must be programmed during

installation.

REMOTE SENSOR BYPASS

To arm the system and bypass the shock sen-

sor, press button 1 to arm, then within 2 sec-

onds press button 1 again.The siren will chirp

5 times and sensors will be ignored until the

3

* Optional Feature

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire